|
|
 |
 |
 |
KB95: Stagger blankingCategory: Miscellaneous Tips | Updated: 6/12/2007 8:27:30 AM | Owner: The Professor | Read: 2268 (Last: 6/17/2013 2:10:45 PM)
ResolutionIf you are blanking one circle out of a strip you could recognize a 7% material savings blanking 2 across or up to 13% at 4 across. Is this a feasibility in your operation? In some cases the wider material is run through the same die, then rewound and run again down the other side. Other plants use an oscillating feed to position first one side then the other into the die, particularly in transfer press operations.
Related articles
KB89 Proper set-up
KB90 Minimum pressure
KB91 Audio-visual inspection
KB92 Edge guiding
KB93 Feeding inclined presses
KB94 Using prime material
KB96 Coil-equipped dies
KB97 Control stations
KB98 Continuous running
KB99 Channel iron protectors
KB100 Guarding at installation
KB101 Operator instructions
Was this article helpful?
Votes so far: 50% in 1137
Yes | No |
|
|
|
|
