|
|
 |
 |
 |
KB49: Correcting loop distortionCategory: Straightening Process | Updated: 6/4/2007 3:14:27 PM | Owner: The Professor | Read: 1999 (Last: 5/18/2013 4:33:08 AM)
ResolutionIf proper looping area is allowed after straightening, material should not be re-distorted. If re-distortion does occur due to slightly inadequate space availability, and in spite of the most careful material support provisions, it is often possible to remove this mild distortion with a simple pull-through straightener after the looping area.
Related articles
KB40 How many rolls?
KB41 What roll diameters?
KB42 Backed up rolls?
KB43 The odd roll principle.
KB44 From bottom of coil.
KB45 The “overshot” roll
KB46 Ability to straighten
KB47 Recording roll settings
KB48 Using dial indicators
KB50 Two-plane straightening
KB51 Dual-head straightening
KB52 Angular head straightener
Was this article helpful?
Votes so far: 50% in 1147
Yes | No |
|
|
|
|
